Remove GIGA alteration (unrelated PR)

Author: pedromsousalima

content/micropython/01.basics/05.digital-analog-pins/digital-analog-pins.md

@@ -134,31 +134,4 @@ pwm.freq(1000)
 while True:
     pwm.duty_u16(duty)
 ```
-
-### PWM on GIGA (STM32)
-
-On STM32 boards like the GIGA R1, the PWM setup is slightly different. You need to use the `Timer` module along with the `Pin` module to configure PWM.
-
-Here's how you can set up PWM on STM32 boards:
-
-```python
-from machine import Pin, Timer
-
-pin1 = Pin("PC6", Pin.OUT_PP, Pin.PULL_NONE)
-timer1 = Timer(3, freq=1000)
-channel1 = timer1.channel(1, Timer.PWM, pin=pin1, pulse_width=0)
-
-duty = 50  # Duty cycle percentage (0-100)
-
-while True:
-    channel1.pulse_width_percent(duty)
-```
-
-In this example:
-
-- `pin1` is configured as an output pin with no pull-up or pull-down resistors.
-- `timer1` is initialized with a frequency of 1000 Hz.
-- `channel1` is created on timer 3, channel 1, and is set to PWM mode.
-- `channel1.pulse_width_percent(duty)` sets the duty cycle of the PWM
-
-***Note: Always refer to your board's documentation for the correct pin names and timer configurations specific to the GIGA. For more information, check out the [GIGA R1 MicroPython Guide](https://docs.arduino.cc/tutorials/giga-r1-wifi/giga-micropython/).***
+```