Merge pull request #1974 from arduino/jhansson-ard-patch-2

Update content.md

Author: jhansson-ard

content/hardware/02.hero/boards/uno-rev3/tutorials/board-anatomy/content.md

@@ -9,24 +9,15 @@ Arduino boards senses the environment by receiving inputs from many sensors, and
 
 ![The Arduino UNO.](assets/BoardAnatomy.svg)
 
-- 1. **Digital pins** Use these pins with digitalRead(), digitalWrite(), and analogWrite(). analogWrite() works only on the pins with the PWM symbol.
-
-- 2. **Pin 13 LED** The only actuator built-in to your board. Besides being a handy target for your first blink sketch, this LED is very useful for debugging.
-
-- 3. **Power LED** Indicates that your Arduino is receiving power. Useful for debugging.
-
-- 4. **ATmega microcontroller** The heart of your board.
-
-- 5. **Analog in** Use these pins with analogRead().
-
-- 6. **GND and 5V pins** Use these pins to provide +5V power and ground to your circuits.
-
-- 7. **Power connector** This is how you power your Arduino when it's not plugged into a USB port for power. Can accept voltages between 7-12V.
-
-- 8. **TX and RX LEDs** These LEDs indicate communication between your Arduino and your computer. Expect them to flicker rapidly during sketch upload as well as during serial communication. Useful for debugging.
-
-- 9. **USB port** Used for powering your Arduino UNO, uploading your sketches to your Arduino, and for communicating with your Arduino sketch (via Serial. println() etc.).
-
-- 10. **Reset button** Resets the ATmega microcontroller.
+1. **Digital pins** Use these pins with digitalRead(), digitalWrite(), and analogWrite(). analogWrite() works only on the pins with the PWM symbol.
+2. **Pin 13 LED** The only actuator built-in to your board. Besides being a handy target for your first blink sketch, this LED is very useful for debugging.
+3. **Power LED** Indicates that your Arduino is receiving power. Useful for debugging.
+4. **ATmega microcontroller** The heart of your board.
+5. **Analog in** Use these pins with analogRead().
+6. **GND and 5V pins** Use these pins to provide +5V power and ground to your circuits.
+7. **Power connector** This is how you power your Arduino when it's not plugged into a USB port for power. Can accept voltages between 7-12V.
+8. **TX and RX LEDs** These LEDs indicate communication between your Arduino and your computer. Expect them to flicker rapidly during sketch upload as well as during serial communication. Useful for debugging.
+9. **USB port** Used for powering your Arduino UNO, uploading your sketches to your Arduino, and for communicating with your Arduino sketch (via Serial. println() etc.).
+10. **Reset button** Resets the ATmega microcontroller.
 
 The text of the Arduino getting started guide is licensed under a [Creative Commons Attribution-ShareAlike 3.0 License](http://creativecommons.org/licenses/by-sa/3.0/). Code samples in the guide are released into the public domain.